BlueprintCalcs 2D Parametric Trade Tools
Solar, Energy Storage & Off-Grid Systems

Solar & Energy Storage Calculators

Parametric 2D CAD engineering calculation workstations for solar PV installers, off-grid homesteaders, and battery system designers. Calibrated to NREL solar irradiance standards, NEC 690 & 705 photovoltaic codes, and manufacturer battery discharge curves.

Solar Panel Tilt Angle Sizer

Calculate optimal fixed, winter, and summer solar module tilt angles by geographic latitude with roof pitch slope compensation and sun elevation curves.

Launch Interactive CAD Engine →

Battery Runtime & Load Sizer

Determine continuous and surge battery bank runtime in hours for Lithium LiFePO4, AGM, and Lead-Acid chemistries under Peukert's Law and Depth of Discharge (DoD).

Launch Interactive CAD Engine →

Off-Grid Solar Daily Wh Estimator

Size complete off-grid solar arrays, daily watt-hour consumption budgets, peak sun hour solar array wattage, and battery bank autonomy days.

Launch Interactive CAD Engine →

Amp Hours to Watt Hours Tool

Convert battery capacity from Amp-Hours (Ah) to Watt-Hours (Wh) across 12V, 24V, 48V, and custom nominal voltages with interactive battery cell schematics.

Launch Interactive CAD Engine →

Watt Hours to Amp Hours Tool

Convert stored energy from Watt-Hours (Wh) and Kilowatt-Hours (kWh) to required Amp-Hours (Ah) for precise off-grid battery bank bank sizing.

Launch Interactive CAD Engine →

Inverter Sizing & Surge Estimator

Calculate pure sine wave inverter continuous watts and motor startup surge capacity (Locked Rotor Amps) for off-grid and backup power systems.

Launch Interactive CAD Engine →

DC to AC Inverter Draw Sizer

Calculate DC battery bank current draw in amps through inverter efficiency losses, DC cable conductor sizes, and fusing requirements.

Launch Interactive CAD Engine →

Generator Wire Gauge & Distance

Size generator cord conductors and transfer switch feed cables for 120V and 240V running/surge wattages up to 300 feet under NEC 310 ampacities.

Launch Interactive CAD Engine →

Contractor & Off-Grid Solar Engineering Standards

Solar photovoltaic arrays and battery storage banks operate under extreme direct current (DC) thermal and voltage drop stresses. BlueprintCalcs implements rigorous calculation models:

NEC Article 690 & 705

DC array wire sizing requires 125% continuous current factoring and temperature derating for rooftop raceways reaching 120°F+ ambient heat.

Lithium LiFePO4 vs Lead-Acid

Battery sizing distinguishes between 80-90% usable DoD for LiFePO4 and strict 50% DoD limits for flooded/AGM lead-acid banks to avoid cycle death.

Inverter Surge Multipliers

Inductive compressor and motor loads (refrigerators, well pumps) demand 200% to 300% Locked Rotor Amps (LRA) head-room on pure sine wave inverters.